Bent track from a backed-into bumper or a worn roller riding rough can pull a door clean off its rails. We fix the immediate problem and the root cause.
Fixing the symptom without finding the cause usually means the same problem returns within weeks.
Track sections are realigned to true plumb and level, verified with the same tools a new installation would use.
Track that's visibly bent or dented from impact gets replaced rather than hammered back into shape.
Vehicle impacts often bend both the track and the bracket mounting it to the frame. We check both.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
Track sections are checked for plumb and level, then adjusted and secured to the frame at the correct tolerance.
Visibly bent or dented track sections get swapped for new standard sections rather than bent back into shape.
A roller jumping the track repeatedly usually means the rollers themselves need replacing along with the fix.
Collision damage often affects more than the visible dent. We check the full track and frame mounting system.
A track can only stay aligned if the brackets holding it are solid. We check and correct this on every off-track call.
Describing the symptom helps us bring the right track sections and hardware on the first trip.
Technicians carry standard track sections and mounting hardware for common configurations.
We check the track, rollers, and brackets together to find the root cause before quoting the fix.
Track realigned or replaced, verified plumb, and tested through a full cycle before we leave.
“Roller kept jumping the track every few days until they found the real cause, a bent bracket.”
“Track was off plumb by more than it looked. Fixed properly instead of a quick patch.”
“Appreciated that they checked the wall brackets too, not just the visible bent section.”
Usually a worn roller, a bent track section, a loose bracket, or an impact from a vehicle or debris.
This is a job for a trained technician given the tension and alignment involved.
We'll assess the severity and recommend replacement when straightening won't hold up long-term.
Pricing varies with the extent of the damage, quoted upfront before any repair begins.
Continuing to run an off-track door usually causes more damage to the track, rollers, and panel.
A straightforward realignment often takes under an hour; a full section replacement may take a bit longer.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of Locust to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Locust, NC